This video will explain the meaning and importance of creating a good ‘Gain Structure’ on your amplifier. This technique will make your sound engineer very …

source

  1. I ALWAYS run the Master volume at FULL, then adjust the gain and EQ. I have found that running my bass amp this way, is the BEST way to get a nice clean signal because my signal to noise ratio is much lower, therefore giving me a nice CLEAN sound. I don't get any hiss, or other anomalies.

  2. For the people who don't have a peak light it's gonna be a bit tougher but nothing you can't manage. At low volume play a strong note like he did and higher your gain until you notice the signal distorts and is not clean anymore. Back up the gain a little bit. Set the volume at the desired level. You're all set.

Leave a Reply